Oase Bitron Serie Instrucciones De Uso página 14

a
UVC
Bypass
¾"
1''
1 ¼''
1 ½''
14
GB Operating instructions
5.1.2 Connection on the Biotec 4
- Screw nut G1 ½" (1f) and intake nozzle (18a) (supplied with Biotec 4) onto
the upper threaded duct.
Point the intake nozzle (18a) downwards and lock it with nut (1f).
-
- Place the air hose (18b) (supplied with Biotec 4) onto the Biotec intake nozzle
(18a).
- Thread the large flat gasket (18c) (supplied with Biotec 4) onto the Bitron
housing duct.
Remove the lid of the Biotec 4.
-
- Insert the Bitron in the filter housing.
Screw the G1 ½" nut (1f) onto the threaded duct.
-
Adjust the bypass according to 5.2 and connect the hoses according to 5.3.
-
18a 18b
5.2 Bypass settings
The water flow-rate can be adjusted through the bypass system, to achieve
optimal water treatment.
- Place the throttle turn handle (a) on the appropriate pump.
5.3 Hose connection
- Only operate the Bitron with pressure hoses that are approved for at least
0.5 bar, or for the maximum pump pressure.
Hose recommendation: Aquamax 2000 1 inch
- To avoid pressure loss, saw off the stepped hose adapter at the appropriate
point for the respective hose.
- Avoid unnecessary angles and curves that lead to additional pressure loss.
- To insure the function of the cleaning rotor (3), the UVC 9C/11C intake nozzle
must be inserted in the supply duct in the case of low water flow-through.
For Aquamax 2000 and 3500 the UVC 9C/11C (1e) intake nozzle must always
be inserted.
1f
Aquamax 3500
Aquamax 5500
18c 1e
1f
1 ¼ inch
1 ¼ - 1 ½ inch
GB
1b
1c 1a