Care And Maintenance - HealthSmart 04–875–001 Manual De Instrucciones

CARE AND MAINTENANCE

1. Only use a soft, dry cloth to clean your blood pressure monitor.
2. Avoid using any types of liquids on the monitor or cuff.
3. Store your monitor in the provided storage case when not in use.
4. Do not store the unit where it will be exposed to direct sunlight, dust or humidity.
Avoid extreme temperatures.
5. Never disassemble the monitor or cuff.
6. Dropping or subjecting your blood pressure monitor to strong shocks should
be avoided.
7. Remove batteries prior to storing.
8. It is recommended the cuff should be disinfected 2 times every week or as needed
(for example, in hospitals or clinics). Wipe the inner side (the side that contacts skin)
of the cuff with a soft cloth squeezed after moistened with Ethyl alcohol (75-90%),
then dry the cuff by airing.
9. No component can be maintained by user in the monitor. The circuit diagrams,
component part lists, descriptions, calibration instructions, or other information
which will assist appropriately qualified technical personnel to repair parts
designated repairable, can be supplied.
10. It is recommended the performance should be checked every 2 years or after repair.
Please contact the service center to schedule.
11. Please keep the cuff clean. If the cuff becomes dirty, remove it from the monitor and
clean by hand in a mild detergent, then rinse thoroughly in cold water. Never dry
the cuff in clothes dryer or iron it. Cleaning the cuff after every 200 measurements is
recommended.
12. The monitor can maintain the safety and performance characteristics for a minimum
of 10,000 measurements or three years.
13. Cuff integrity is maintained for 1,000 open–close cycles.
22