Drawing Up The Bobbin Thread; Straight Stitch And Zigzag Stitch; Starting Sewing - EURO-PRO 473 Manual De Instrucciones

DRAWING UP THE BOBBIN THREAD

1.Hold the end of the needle thread with your left hand.
2.Turn the balance wheel slowly towards you with your right
hand until the needle goes down and comes up. Then stop
the balance wheel when the take-up lever is at its highest
position.
Lightly draw up the needle thread forming a loop with the
bobbin thread.
3.Puil about 15cm (6 inches) of both threads away from you
under the presser foot.

STRAIGHT STITCH AND ZIGZAG STITCH

377B
Presser foot
Pattern selector M (
(for straight gtitch)
1 - 5 (54321) (for zigzag stitch)
Stitch length dial

Starting Sewing

1. Be sure both the threads are drawn back under the presser foot.
2. While holding the threads with your left hand, turn the balance
wheel toward you to bring the needle into the fabric where you
wish to start sewing.
3. Lower the presser foot, and press the speed controller gently,
then start sewing slowly.
*Sew a few reverse stitches by pushing reverse button for
reinforcing the end of seams.
*Raise the needle to its
pattern selector dial and stitch width dial.
zigzag foot zigzag foot
O ( )
)
A (
or
(for straight stitch)
C ( ) (for zigzag stitch)
0.3-4
highest position before turning the
1
2
bobbin
thread
473/373/372/372H
374
) B ( )
( ) (for straight stitch)
or
( ) (for zigzag stitch)
0.3-4
11
needle thread
needle
thread
3
-
zigzag foot