DeWalt D26676 Manual De Instrucciones página 8

5. Replace the drum cover (Q) and tighten the three bolts (M).
FIG. 5
O
T
S
R
Sharpening Blades (Fig. 6)
1. Fasten the blade to the sharpening
holder (V). Make sure both blade
edges are facing the
direction.
2. Place the blade edges so they rest
flat on the grinding stone.
3. Firmly grip the sharpening holder
and move it back and forward to
sharpen the blade (O).
OPERATION
WARNING: Always observe the safety instructions and applicable
regulations.
WARNING: To reduce the risk of serious personal injury, turn
tool off and disconnect tool from power source before making
any adjustments or removing/installing
or accessories.
CAUTION: Risk of property damage. Use sharp blades only.
PRIOR TO OPERATION:
• Adjust the depth of cut.
M
Q
T
S
O
U
FIG. 6
V
same
O
attachments
• Fit and adjust the parallel fence, if needed.
Switch (Fig. 1)
WARNING: Check that the tool is not locked on before connect-
ing it to a power supply. If the trigger switch is locked on when the
tool is connected to the power supply, it will start immediately.
Damage to your tool or personal injury may result.
CAUTION: Risk of property damage. Allow the tool to reach full
speed before touching tool to the work surface. Lift the tool from the
work surface before turning the tool off.
To start the planer depress the trigger switch (A). To turn the planer
off, release the trigger switch.
LOCK-ON BUTTON
The tool can be locked on for continuous use. To lock the tool ON
depress the trigger switch (A) and push in the lock-on button (B).
Hold the lock-on button in as you gently release the trigger switch.
The tool will continue to run.
To turn the tool off from a locked-on position, squeeze and release
the trigger once.
Planing (Fig. 1)
CAUTION: Risk of property damage. Allow the tool to reach full
speed before touching tool to the work surface. Lift the tool from the
work surface before turning the tool off.
Place the front of the shoe on the surface to be planed, making
certain that the cutting blades are not touching the surface. Push
down firmly on the front handle of the planer so that the front shoe
is ABSOLUTELY FLAT on the work surface. Turn the tool on and
allow the motor to reach full speed before touching the planer
blades to the work surface.
Move the tool slowly into the work and maintain downward pressure
to keep the planer flat. Be particularly careful to keep the tool flat at
the beginning and the end of the work surface.
6