Voltage Monitor; Binding - Multiplex SMART SX FLEXX Manual De Instrucciones

Transmitter
3.3
3.4
SMART SX FLEXX
the cells.
Appropriate rechargeable batteries may also be used in place of the three
batteries. However, rechargeable battery cells can be charged only outside the
transmitter; a charge socket is not provided. Purchase an appropriate battery
charger.
Operating time
Due to the low energy requirement at 2.4 GHz, the transmitter has an operating
time of up to 25 hours when using the three AA mignon batteries.

Voltage monitor

The SMART SX FLEXX transmitter is equipped with a permanently set warning
function to protect the device against low voltage.
When the battery/rechargeable battery cells are almost flat, an acoustic warning
sounds and the annular light of the power button flashes in red:

Stop operating the model.

Insert new or fully charged cells.

Binding

When establishing a connection between the transmitter and the receiver for the
first time, the two components must be bound to each other. Upon successful
completion of the binding procedure, the receive system is immediately
operational. Therefore, first secure the model in order to prevent it from driving off.
Procedure
1. Switch on the transmitter by pressing and holding the multi-function button.
The annular light of the Power button flashes rapidly in yellow.
2. Switch on the receiver by pressing and holding the SET button.
The status LED on the receiver flashes rapidly in yellow.
3. Position the transmitter and receiver in close proximity to each other. The
transmitting power is significantly reduced during the binding. The distance
may have to be reduced to 20 cm or less.
The binding procedure is completed within a few seconds:

The annular light of the Power button flashes slowly in yellow.
Page 57