Model Memory Id; Firmware Update - Multiplex SMART SX FLEXX Manual De Instrucciones

3.9
3.10
Page 60
The annular light of the Power button is illuminated in solid yellow.
o
The transmitter now emits an acoustic warning signal every 10 seconds.
o
In this condition, the model control must also function at a distance of approx.
50 m. Only then is the full range available in the normal transmitting mode.
3. Switch off the transmitter in order to deactivate the range mode.
4. The transmitter is ready to operate on restart.

Model memory ID

The small, compact 2.4 GHz M-LINK receiver with UNI connector system is
included in the scope of delivery of the set. However, the highlight of this intelligent
receiver is the ID model recognition of the receiver type.
With this feature, the SMART SX FLEXX transmitter recognises your model and
automatically switches to the corresponding model memory. With this, the repeated
resetting of servo rotation directions and trimmings that is generally necessary in
typical entry-level transmitters is no longer required. If you have several models
with ID receivers and change the model, simply switch off the transmitter and
switch it on again. Your model is ready as soon as the acoustic signal indicating ID
recognition is emitted.
The model data sets can also be overwritten or adjusted at the transmitter end, so
that the ID receivers are universally deployable.
The RX-5 ID receiver can also be operated with any other M-LINK radio control
without ID recognition; in that case, it corresponds to a normal receiver RX-5 light
M-LINK 2.4 GHz.
Moreover, other M-LINK receivers (light or telemetry) can also be operated with the
SMART SX FLEXX transmitter. When using a receiver without ID, the SMART SX
FLEXX remains on the default model memory cell "0" after switching on and the
acoustic signal indicating ID recognition is not emitted. All the configuration options
with automatic, permanent storage are available here as well.

Firmware update

A new firmware update can be loaded in the memory of the SMART SX FLEXX
transmitter, which enables you to keep up with the latest technical standards at all
times.
For establishing a connection between the PC and the SMART SX FLEXX, you
need a USB adapter with UNI connector (see section 10.2 "Scope of delivery and
accessories" on page 84).
Transmitter
SMART SX FLEXX