Safety Information Regarding The Charging Unit; Assembly (02, 10) - AL-KO Easy Flex HTA 2050 Manual De Instrucciones

GB
6.2 Safety information regarding the
charging unit
This section mentions all the basic safety and
warning information to be heeded when using the
charger. Read these instructions.
■
Only use the appliance as designated, i.e. for
charging the intended rechargeable batteries.
Only charge original rechargeable batteries
from AL-KO in the charging unit.
■
Before each use, inspect the entire appliance
– and especially the mains cable and the re-
chargeable battery compartment – for dam-
age. Only use the appliance when it is in a
proper working order.
■
Do not use the appliance in environments
where there is a potential risk of explosion
and/or fire.
■
Only operate the appliance indoors and do
not expose it to moisture and humidity.
■
Always place the charging unit on a well ven-
tilated and non-inflammable surface because
it heats up during the charging process. Keep
the ventilation slots clear and do not cover
the appliance.
■
Before connecting the charging unit, make
sure that the mains voltage matches the volt-
age stated in the "Technical data".
■
Only use the mains cable for connecting the
charging unit, not for other purposes. Do not
carry the charging unit by the mains cable
and do not remove the power plug from the
power outlet by pulling on the mains cable.
■
Protect the mains cable from heat, oil and
sharp edges to prevent it being damaged.
■
Do not use the charging unit and recharge-
able battery when soiled or wet. Before using
the appliance, clean and dry the recharge-
able battery.
■
Do not open the charging unit or recharge-
able battery. There is a danger of electric
shock and short-circuit.
■
For your own safety, have your appliance re-
paired by qualified specialist personnel only
using original spare parts.
■
This appliance must not be used by unautho-
rised persons unless they are supervised by
a person responsible for their safety or have
been instructed on how to use the appliance.
Unauthorised persons include, for example:
■
Persons (including children) with limited
physical, sensory or mental aptitude
32
■
Persons who have no experience and/or
knowledge of the appliance.
■
Children must be supervised and instructed
so they do not play with the appliance.
■
Dry unused appliances and store in a closed
place. Unauthorised persons and children
must not have access to the appliance.

7 ASSEMBLY (02, 10)

WARNING!
Danger if assembly is not carried out
completely!
Operation of an incompletely assembled
appliance can result in serious injury.
■
Only operate the appliance when it is
fully assembled.
■
Do not insert the battery into the ap-
pliance until it is fully assembled.
■
Check that all safety and protective
devices are in place and functioning
correctly before switching on.
Mount the cutter head onto the telescopic
pole
1. Align the cutter head (02/1) and telescopic
pole (02/2) with one another.
2. Slide the coupling (02/3) and coupling coun-
terpart (02/4) inside each other up to the end
stop (02/a).
3. Screw the coupling (02/3) tight.
Remove the cutter head from the telescopic
pole
1. Unscrew the coupling (02/3).
2. Pull apart (02/b) the cutter head (02/1) and
telescopic pole (02/2).
Attaching the carrying belt to the basic
appliance (10)
The supplied carrying belt transfers the load onto
your upper body.
1. Hang the carrying belt (10/2) over your shoul-
der.
2. Hook the snap hook of the carrying belt into
the eye (10/1) on the appliance.
3. Adjust the length of the carrying belt by mov-
ing the buckle on the carrying belt so that the
appliance is comfortable to carry.
Assembly (02, 10)
HTA 2050