GB
16 HELP IN CASE OF MALFUNCTION
CAUTION!
Risk of injury
Sharp-edged and moving appliance parts can lead to injury.
■
Always wear protective gloves during maintenance, care and cleaning work.
Malfunction
Engine does not run.
Motor keeps cutting out.
Cutting blade becomes hot
when running. Generation of
smoke.
Branches are not cleanly cut.
Branches are often jammed
in the cutting blade.
Motor running, but the cutting
blade does not move.
Appliance vibrates unusually. Appliance faults
Rechargeable battery operat-
ing time is significantly short-
er.
Rechargeable battery cannot
be charged.
38
Cause
Rechargeable battery is flat.
Rechargeable battery miss-
ing or rechargeable battery
not seated correctly.
Power supply is interrupted.
The motor protection switch
has switched off the motor
due to overload.
■
Appliance faults
■
The On/Off switch is de-
fective.
No oil on the cutting blade.
■
Cutting blade is blunt.
■
Nicks in the cutting
blade.
Cutting blade is blunt.
The sliding play of the cutting
blade is too great.
Appliance faults
The service life of the re-
chargeable battery has ex-
pired.
Rechargeable battery con-
tacts are dirty.
Rechargeable battery or
charging unit is defective.
Rechargeable battery is too
hot.
Help in case of malfunction
Remedy
Charge the rechargeable battery.
Insert the rechargeable battery cor-
rectly.
1. Remove the battery.
2. Clean the plug contacts of the ap-
pliance.
Wait until the motor protection switch
enables the motor again.
Contact an AL-KO service centre.
1. Switch off the appliance and re-
move the rechargeable battery.
2. Clean and oil the cutting blade.
3. Insert the rechargeable battery
again.
Contact an AL-KO service centre.
Contact an AL-KO service centre.
Contact an AL-KO service centre.
Contact an AL-KO service centre.
Contact an AL-KO service centre.
Replace the rechargeable battery.
Only use genuine accessories from
the manufacturer.
Contact an AL-KO service centre.
Order spare parts. Contact an AL-KO
service centre.
Allow the battery to cool down.
HTA 2050