TAKING CARE OF UNEXPECTED PROBLEMS
CONTROL BOX
(Indicator type)
OIL ALERT
INDICATOR
To perform the oil alert indicator check, the engine must be
connected to a battery and the engine switch must be in the ON
position.
ENGINE WILL NOT START
Possible Cause
Fuse burnt out.
Fuel, engine oil, spark
plug, etc.
Engine oil level low.
ECM, sensors, etc.
Battery discharged.
Choke closed.
Engine switch OFF.
Out of fuel.
Bad fuel; engine stored
without treating or
draining gasoline, or
refueled with bad
gasoline.
Spark plug faulty, fouled,
or improperly gapped.
Spark plug wet with fuel
(flooded engine).
Fuel filter restricted,
carburetor malfunction,
ignition malfunction,
valves stuck, etc.
CONTROL BOX
(Hour meter type)
OIL ALERT
INDICATOR
Correction
Replace fuse (p. 13).
After replacing fuse, turn the engine
switch to the ON position once again.
Check the BEFORE OPERATION
CHECKS (p. 5).
Fill with the recommended oil to the
proper level (p. 9).
Take engine to your servicing dealer,
or refer to shop manual.
Recharge battery.
Move choke lever to OPEN position
unless the engine is warm.
Turn engine switch to ON position.
Refuel (p. 8).
Drain fuel tank and carburetor (p. 14).
Refuel with fresh gasoline (p. 8).
Gap or replace spark plug (p. 12).
Dry and reinstall spark plug.
Take engine to your servicing dealer,
or refer to shop manual.
ENGINE LACKS POWER
Possible Cause
Filter element(s)
restricted.
Bad fuel; engine stored
without treating or
draining gasoline, or
refueled with bad
gasoline.
Fuel filter restricted,
carburetor malfunction,
ignition malfunction,
valves stuck, etc.
ENGLISH
Correction
Clean or replace filter element(s)
(p. 10).
Drain fuel tank and carburetor (p. 14).
Refuel with fresh gasoline (p. 8).
Take engine to your servicing dealer,
or refer to shop manual.
15