Installation And Connection - Bartscher 110801 Manual Del Usario

•
The power cable must not be folded, bent or tangled, and must always remain fully
unrolled.
•
Never place the device or other objects on the power cable.
•
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep
away the cable from operating range and do not dunk it into water.
•
Do not use the device in case it does not function properly, has been damaged or
dropped.
•
Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the
device or personal injury, and further, the warranty expires.
•
Do not spray the device with water, do not expose the device to precipitation,
dripping water or other wetness.
•
Never operate the device with wet or moist hands, do not approach the device with
bare feet. Danger of electric shock!
•
Do not drill any holes in the device nor mount any objects on it.
•
Do not place any heavy objects on the device.

5.2 Installation and connection

Setup
•
Unpack the device while on the pallet and remove all packing material.
•
Use a forklift to lift the device and move it to its destination. Remove the pallet and
put the device in its proper place.
•
Never pull or push the device around, as it can turn over and the body or legs can
be damaged.
•
Put the device in a safe place capable of supporting its weight.
•
Never place the device on a flammable surface.
•
Do not put the device near open flame, electric oven, heater or other source of heat
such as direct sunlight. High temperatures can have a negative impact on the
device's performance and increase energy usage.
•
Locate the device so that sufficient air circulation is ensured. Maintain a distance of
at least 5 cm from the rear of the device, 10 cm at the sides and 30 cm from the
ceiling and/or shelves.
•
Never cover the device's ventilation openings.
•
Do not locate the device in placed with high humidity. Excessive humidity
can damage the device.
•
Level the device using the legs.
•
Remove the protective film from the device.
- 30 -