Bartscher 110801 Manual Del Usario página 43

Alarms and messages
If an alarm is activated, a message is shown on the display alternating with the
temperature; an audio signal may also be heard.
All alarms are reset automatically (this is why messages disappear when the cause of
the alarm disappears; only "CHt" must be reset manually by turning the device off and
then on again by
Pressing will turn the audio signal off, while the code and message will disappear
when the cause of the alarm is fixed. Below is a table of alarm codes.
Alarm Audio
code signal
E0
Active
E1
Inactive
E2 Inactive
IA
Active
dOr
Active
LO
Active
HI
Active
EE
Inactive
EF
Inactive
Ed
Inactive
dF
Inactive
cht
Inactive
CHt
Active
EtC Inactive
or by disconnecting from the power source).
LED
ON Sensor error 1 = regulation
ON Sensor error 2 = defrost
Sensor error 3 = condenser/
ON
product
ON External alarm
ON Open door alarm
ON Low temperature alarm
ON High temperature alarm
ON Device parameter error
ON Operating parameter error
ON Defrost time-out
OFF Defrost
Initial alarm indicating dirty
ON
condenser
Alarm indicating dirty
ON
condenser
ON Clock alarm
Description Reset
Automatically
Automatically
Automatically
Automatically
Automatically
Automatically
Automatically
Not possible
Manually
Following first
properly-
completed defrost
cycle
Automatically
Automatically
Manually
By setting clock
- 39 -