Enerpac ZW3 Serie Hoja De Instrucciones página 8

K. "Retract" Menu
Screen 12
RETRACT
334
HOURS CYCLES
(See Screen 12.) This screen allows the operator to read the
number of hours (On/Off cycles) the Retract solenoid has been
operated. Toggle between hours and cycles by pushing either
the Down or Up Arrow button. Step forward by pressing the
Menu button. See QRC step 8.
_______________________________________________________
General note for all hour and cycle displays:
HOURS DISPLAYED
- up to 9999.9 the display will show decimal hours
- between 10,000 - 99,999 whole hours will be displayed (decimal "." is not
displayed).
- over 99,999 hours the meter starts over at 0.0 reading decimal hours
CYCLES DISPLAYED
- over 99,999 cycles the meter starts over at 0
_________________________________________________________
L. "Local" Menu
Screen 13
SET
OFF
(See Screen 13.) This screen allows the operator to toggle the Local
mode ON or OFF. With Local mode ON, the shroud buttons replace
the pendant buttons as the method to operate the pump (Note:
The word "Local" replaces "READY" on the "Normal Operations"
display and the pendant buttons become deactivated).
Local mode will provide operation of the pump if the pendant
or pendant cord is damaged. Toggle Local mode ON or OFF
by pressing the Down (Up) Arrow button. Save setting and step
forward by pressing the Menu button. See QRC step 9.
Local mode OFF is the default value. Local mode ON will revert
to Local mode OFF if power is disconnected.
M. "Language" Menu
Screen 14
ENGLISH
SET
(See Screen 14.) With a language shown on the text display the
operator can change the display language by pressing the Down
(Up) Arrow buttons. Save setting and step forward by pressing the
Menu button. See QRC step 10.
LOCAL
N. "Diagnose" Menu
Screen 15
DIAGNOSE
SET
00001
Pendant DOWN ARROW Button
Pendant UP ARROW Button
Pendant ON/OFF Button
(See Screen 15.) This screen allows the operator to troubleshoot
several pendant problems by displaying if the microcontroller has
received a signal from the pendant button. No signal indicates the
problem is most likely with the pendant keypad or pendant cord.
Use Local mode to operate pump until problem can be corrected.
See QRC step 11.
Screen 16
Press
(See Screen 16.) Diagnose screen with Pendant motor button
pushed.
Screen 17
Press
(See Screen 17.) Diagnose screen with Pendant Advance button
pushed.
Screen 18
Press
(See Screen 18.) Diagnose screen with Pendant Retract button pushed.
8
PSI
(not used)
Fan
DIAGNOSE
10001 PSI
DIAGNOSE
01001 PSI
DIAGNOSE
00101
PSI