Ingersoll Rand SSR UP5-4 Manual De Operación Y Mantenimiento página 25

OPeRATIOn AnD MAInTenAnCe MAnUAL
KeY
A Package pre-filler
B Hole, incoming power supply conduit
C
Gauge, pressure
D
Yellow stand–by light
e
Green power–on light
F
Green start push button
G
Emergency stop button
H
Hourmeter
I Starter box
J Lifting points
K Mounting holes ( x 1.5mm [0."] x .5mm
[1.5"] slots)
L Filter, air inlet
M Motor
n
Integrated dryer (Optional)
O
Compressor and cooling air intake
nOTeS
1. Foundation or floor must be level and support all
mounting bolt locations equally. If necessary, shim
or grout the fourth bolt location.
2. Foundation bolts should protect thru nuts a
minimum of 1mm (0.50") to allow for levelling.
. Allow a minimum clearance of 1100mm (2") on
the front and 20mm (") on the top, left right
and rear of the package for proper air circulation
and serviceability.
. Approximate package weight: 0kg (lbs).
5. External piping shall not exert any unresolved
moments or forces on the unit. Use pipe size as
large or larger at discharge connection.
. There should be no plastic or pvc piping attached
to this unit or used for any lines downstream.
. Do not pipe into a common header with a
reciprocating compressor, unless the reciprocating
compressor utilizes a discharge pulsation damper.
. Sizing of electrical components not supplied
by Ingersoll Rand is the responsibility of the
customer and should be done in accordance with
the information on the compressor data plate and
national and local electrical codes.
P Filter, coolant
Q Cartridge, coolant separator
R
Valve, airend relief
S
Plug, coolant filler
T
Sight–glass
U
Plug, coolant drain
V
Valve, pilot
w
Switch, pressure
X Cooling air exhaust
1A Valve, ball 0.5" N.P.T.
1B Air receiver (Ø 1.0mm x 101.0mm LG) ( Ø 2."
x .00" LG)
1C Location for manual receiver drain
1D Valve, receiver relief
1e
0.25" discharge port for optional electric drain valve
All dimensions are in millimetres (inches) unless
otherwise stated.
Ensure that the correct fork lift truck slots or marked
lifting points are used whenever the machine is lifted or
transported.
UnPACKInG
The compressor will normally be delivered with a
polythene cover. If a knife has to be used to remove
this cover ensure that the exterior paintwork of the
compressor is not damaged.
Ensure that all transport and packing materials are
discarded in a manner prescribed by local codes.
InSTALLATIOn / HAnDLInG
nOTe
25