Installation And Setup - Chemfree SW-23 Manual De Operación

SmartWash
Operating Manual
Your SmartWasher
support grid and false bottom of the sink are packed inside the sink).
Visually inspect for damage (minor scratches and scuffs are normal
due to the molding process).
The SmartWasher
enough to a normal 115VAC (220VAC) Ground Fault Circuit Interrupter (GFCI) electrical outlet so that it can be
plugged in. The SmartWasher should be the only item plugged into this circuit. Do not plug in before adding fluid.
PARTS WASHER SETUP
MAT SUPPORT GRID
1. Remove the OzzyMat
on the mat support grid located in the lowest level in the sink.
Make sure to lay the OzzyMat white side up.
2. Place the false bottom in position in the sink.
3. Form the flexible nozzle to its desired shape and be sure
that the parts brush is inside the sink.
4. At start up, carefully add 15 gallons (three 5-gallon boxes)
of OzzyJuice
solution directly into the sink.
5. Plug the unit in to a 115V (220VAC) GFCI electrical outlet.
6. The SmartWasher will take approximately four hours to heat
up to its selected optimal temperature of 108°F (+-2°)
(42°C)(+-1°)
temperature will be maintained as long as the SmartWasher
is plugged in and full of OzzyJuice. (If the low fluid light is on,
the heater automatically shuts off.)
CHECK LOCAL REGULATIONS:
1
ChemFree Technical Support : 800-521-7182 www.chemfree.com
r e
®
Ozzy ®
is shipped fully assembled. (The OzzyMat
®
will weigh approximately 300 pounds (136 Kg) when it is filled with fluid. It should be installed close
®
FALSE BOTTOM
OZZYMAT™
from its package, unfold it and lay it
™
to the SmartWasher by slowly pouring the
®
OR 115° F(+-2°)
You may be able to dispose of your used OzzyMat as solid waste or with your other absorbent mats.

INSTALLATION AND SETUP

,
™
(46°C)(+-1°). This
Remove the false bottom and check to make
sure the mat support grid is in the bottom of the
sink. Remove and discard packing material.
PARTS WASHER OPERATION
1. The pump switch is attached to a ten or
thirty minute timer. Turning the switch
ON (upward position) will start fluid
flowing for ten or thirty minutes. To restart
the flow, turn the switch OFF then ON
again and the flow will restart for another
ten or thirty minutes.
2.
Adjust the valve at the base of the
faucet to control the flow of the fluid
through the faucet. The valve at the
base of the brush hose controls the flow
of fluid through the brush. Both outlets
can be operated independently or
together.
BRAKE WASHER OPERATION:
1. Unplug the SmartWasher
electrical outlet, roll up the power cord
and secure it with the strap on the
handle.
2.
Roll the SmartWasher
and position it under the brake you
desire to clean.
3.
Plug in the power cord and begin
cleaning.
4.
When finished, unplug the power cord
and secure it with the strap on the
handle. Roll the SmartWasher
its original spot and plug the power cord
into the appropriate outlet.
from the
®
to the vehicle
®
back to
®