IKRA BT 2335 Instrucciones De Manejo página 20

not wear open-toed footwear, or go barefooted or
barelegged. Under certain circumstances, you must
wear full face and head protection. Pay attention to
kickback and strokes of the device.
NO PERSON EXCEPT THE OPERATOR IS AL-
LOWED WITHIN THE DANGER ZONE, I.E., IN A RA-
DIUS OF 15 METERS AROUND THE OPERATOR.
THE OPERATOR MUST WEAR EYE, EAR, FACE,
FOOT, LEG AND BODY PROTECTION. PERSONS
INSIDE THE DANGER ZONE OR RISK ZONE BE-
YOND THE DANGER ZONE SHOULD WEAR EYE
PROTECTION AGAINST THROWN OBJECTS. RISK
DIMINISHES WITH AN INCREASING DISTANCE
FROM THE DANGER ZONE.
CUTTING WITH A NYLON CUTTING HEAD
WARNING DANGER
LINE CUTTER
Always use the protection cover with line cutter when
using a nylon cutting head. Otherwise, the nylon cut-
ting line may flap around if it is too long.
OBJECTS
CUT ON THIS SIDE
For nearly all cutting applications, it is recommended to
tilt the cutting head such that contact between cutting
line and cut-off matter is made in the part of the line's
circular movement, where it is moving AWAY from the
operator and protection cover (see appropriate figure).
This results in caught objects and cut-off matter being
thrown AWAY from the operator.
DANGER ZONE
CLOCKWISE ROTATION
WARNING DANGER
Tilting the head to the wrong side results in the cut-
off matter being thrown TOWARDS the operator. If
the cutting head is held in a horizontal position to the
ground so that cutting occurs over the whole cutting
circle of the line, cut-off matter will be THROWN at the
operator, the high workload will slow the engine down,
and you will use up a lot of line.
Use only quality nylon monofilament line with a diam-
eter of 1,8 mm. Never use wire or wire-reinforced line
instead of nylon trimmer line. Load your nylon cutting
head with nylon trimmer line of the proper diameter
only.
Use extreme caution when cutting over bare spots
and gravel as the line can throw small stones at high
speeds. The protection cover on the unit cannot hold
back objects that bounce back or rebound from hard
surfaces.
TRIMMEN
ANGLE TO WALL
Trimming means feeding the trimmer carefully into the
material you wish to cut. Tilt the head slightly to di-
rect cut-off matter and caught objects away from you.
If cutting up to a barrier such as a fence, wall or tree,
approach from an angle where any objects bouncing
back from the barrier will fly away from you. Move the
cutting head slowly until the grass is cut right up to the
barrier – but do not push (overfeed) the line into the
barrier. If trimming up to a wire mesh or chain linked
fence be careful to feed only up to wire. If you go to
far the line will get caught and wrap itself around the
wire. Using the trimmer you may also cut through weed
stems one at a time. To do so, place the cutting head
near the bottom of the weed – never higher up as this
could cause the weed to chatter and catch the line.
Rather than cutting the weed right through, just use the
very end of the line to wear through the stem slowly.
WARNING DANGER
Do not to use a steel blade for edging or scalping.
GB-5
OBJECTS
KNIFE SIDE RAISED
ANGLE TO
GROUND