Setting Up The Saneo Bw, Saneo Cw, Saneo Bs, Saneo Cs, Saneo Blp, Saneo Clp Toilets; Water Connection - Dometic Saneo B Instrucciones De Montaje

Installing the toilet
5.5 Setting up the Saneo BW, Saneo CW, Saneo BS,
Saneo CS, Saneo BLP, Saneo CLP toilets
These models have a wall connection console. The control and operating panel is
integrated in the wall connection console.
Models Saneo BW and Saneo CW feature a built-in water tank, while models
Saneo BS and Saneo CS do not have a water tank.
Set up all models with wall connection console directly against the room wall
(fig. f, page 14). A previously attached wall bracket is used to secure the toilet and
the wall bracket.
➤ Screw on the wall bracket, level, at the following height (fig. g, page 14):
Variant A:
Model
Saneo BW, Saneo BS
Saneo CW, Saneo CS
Saneo BLP, Saneo CLP
Variant B:
– Saneo BW, Saneo BS: h = 661 mm
– Saneo CW, Saneo CS: h = 661 mm
– Saneo BLP, Saneo CLP: h = 478 mm
➤ Put the entire toilet module into the desired position in front of the wall bracket.
➤ Lift the toilet and hook the housing into the wall bracket (fig. h, page 15).
➤ Tightly fasten the base plate with four screws (fig. b 2, page 12).
➤ Insert the caps (fig. b 1, page 12).
➤ Slide in the mobile tank cassette (fig. i, page 15).
5.6

Water connection

I
NOTE
For the Saneo xW models with an integrated water tank, the water con-
nection is installed at the factory.
➤ Connect the water supply using a smooth hose connection (fig. j 1, page 16).
The connection socket is not included in the scope of delivery.
28
A B
170 mm 96 mm
170 mm 96 mm
170 mm 96 mm
Saneo B, Saneo C
C D
645 mm 652 mm
645 mm 652 mm
462 mm 469 mm
EN