Connecting The Device - Dometic PERFECTCHARGE SMP 439A Instrucciones De Montaje

Installing the device
For installation and mounting you will need the following tools:
•
Pen for marking
•
Drill bit set
•
Drill
•
Screwdriver
To secure the device in place you will need:
•
machine bolts (M4 or M5) with washers and self-locking nuts or
•
self-tapping screws or wood screws.
Fasten the device as follows:
➤ Hold the device against the installation location and mark the fastening points.
➤ Fasten the device with one screw through each hole in the holders.
6.2

Connecting the device

Connecting the battery
Observe the following instructions when connecting the battery:
!
CAUTION!
•
Avoid coming into contact with the battery fluid.
•
Batteries with a cell short circuit may not be charged, as explosive
gases may form due to overheating of the battery.
•
Make sure the battery terminals are clean when connecting them.
•
Make sure the plug connector is fitted securely.
•
Select a connection cable with a sufficient cross-section (suitable for 25 A).
•
Use both the positive and both the negative connections to connect the battery.
•
Lay the cables in accordance with VDE 100 (Germany).
•
Use the following cable colours:
– Red: positive connection
– Black: negative connection
•
Do not reverse the polarity. Reversing the polarity of the connections will cause a
great spark and the internal fuses will melt.
14
SMP439A
EN