Connecting The Coolant; Risk Of Burns - Abicor Binzel ABIPLAS WELD CT Serie Manual De Instrucciones

Antorcha de soldadura
Ocultar thumbs Ver también para ABIPLAS WELD CT Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6 Putting into operation
2 Push the liner through the retaining nipple (4), guide tube (1), guide (5) and cold-wire
tube (6) as far as it will go into the feeding nozzle (7).
3 Tighten the retaining nipple (4) with the wire conduit's nut (3). The liner is securely attached.

6.8 Connecting the coolant

WARNING

Risk of burns

The cable assembly overheats if the coolant level is too low.
• Wear the correct protective gloves.
• Check the coolant level at regular intervals.
NOTICE
• Ensure that the coolant supply and return hoses have been correctly installed. Coolant
supply = blue, coolant return = red
• Do not use deionised or demineralised water as coolant or for leak and flow tests.
This may shorten your welding torch's service life.
• For liquid-cooled welding torches, we recommend using ABICOR BINZEL BTC coolant.
 Please consult the applicable safety data sheet.
1
1
Coolant return hose
2
Coolant supply hose
Fig. 8
Connecting the coolant
Bleed the entire cooling system as follows when used for the first time and after every cable
assembly replacement:
EN - 16
2
3
Coolant recirculator
4
Control lead
®
ABIPLAS
WELD CT
3
4
BAL.0128 • 2019-09-04

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Abiplas weld 150 ct20Abiplas weld 250 ct20

Tabla de contenido