Attaching The Connector To The Device; Connecting The Coolant - Abicor Binzel ABIPLAS WELD 100 Instructivo De Servicio

®
ABIPLAS WELD 100/150 POWDER W

6.3 Attaching the connector to the device

6.4 Connecting the coolant

1
4
1 Coolant return hose
2 Coolant supply hose
Fig. 6
Connecting the coolant
BAL.0086 • 2020-12-17
1 Join the central connector and socket at the power source and secure them
with the connection nut.
2 Connect the pilot power cable, control lead cable and powder hose to the
power source and the powder delivery unit.
WARNING
Risk of burns
The cable assembly overheats if the coolant level is too low.
• Wear the correct protective gloves.
• Check the coolant level at regular intervals.
NOTICE
• Ensure that the coolant supply and return hoses have been correctly
installed. Coolant supply = blue, coolant return = red
• Do not use deionised or demineralised water as coolant or for leak and
flow tests.
This may shorten your welding torch's service life.
• For liquid-cooled welding torches, we recommend using
ABICOR BINZEL BTC coolant.
 Please consult the applicable safety data sheet.
3
4
2
Coolant recirculator
Control lead
6 Putting into operation
3
EN - 15