Grandstream GVC3210 Guía De Instalación Rápida página 5

Connecting example
Power Input
12V DC power adapter is
connected into outlet.
Ethernet Port
Connect Ether-
net cable from
GVC3210 LAN port
to hub/switch/router
(LAN side).
USB Ports
MIC/Speaker Inerfaces
Connect speaker to GVC3210
USB port. Use the USB extension
cable in the package if necessary.
USING THE GVC3210 REMOTE CONTROL
LED Indicator
Back
Home
Shortcut Keys
Volume Down
OK
Zoom Out
PIP
Send/Answer/Add
Party Into Conference
Backspace
Standard Keypad
* / Record
Presentation PC
HDMI Input
Connect HDMI cable from
GVC3210 HDMI IN port to
laptop's HDMI port. This is
for presentation.
HDMI Output1
(Primary)
Connect HDMI cable from
the GVC3210 HDMI OUT
port 1 to TV's HDMI port.
HDMI Output 2
(Secondary)
Power ON/OFF
Trackpad
Menu
IPVT-Personal Room
Volume Up
Navigation Keys: Up/Down,
Left/Right
Zoom In
Presentation
End Call / Remove Party
from Conference
Camera
# / Information
Mute / DND
~ 5 ~
1. Open the battery cover on the back of the remote control. Place four AAA bat-
teries proprely and put the cover back on.
2. When using the GVC3210 for the first time, the remote control should be
paired and connected to it via Bluetooth or infrared connection already. After the
GVC3210 fully boots up, tap on the OK button on the remote control to initiate the
connection. Then the remote control can be used normally.
1. Infrared connection:
Users need to keep the two devices in front of each other without any substantial
obstruction in between.
The LED on the remote control is green when using infrared connection mode.
2. Bluetooth connection:
If the remote control is not paired with the GVC3210 anymore (e.g., a factory reset
is made), press OK button and number 5 button at the same time for about 4 sec-
onds. This will initiate pairing process on the remote control and it will be paired
and connected to the GVC3210 shortly.
Notes:
1. Users can also download GVC3210 Bluetooth remote control app for Android™
and install to your Android™ device. This app can be used as an alternative for the
remote control in the GVC3210 package.
2. After the remote control is paired, users could follow the setup wizard to initiate
GVC3210 step-by-step, or skip the setup wizard.
CONFIGURING GVC3210 VIA WEB UI
1. Ensure your GVC3210 is properly powered up and connected to the Internet.
2. The IP address of the GVC3210 will show on the top status bar of the connected
display device (e.g., TV) via HDMI.
3. Type the IP address in your PC's browser (see figure below).
4. The default username and password for administrator are "admin" and "admin".
The default username and password for user are "user" and "123".
For the detailed user manual, please download from:
http://www.grandstream.com/support
~ 6 ~