Cleaning And Care - Beurer HK 25 Instrucciones Para El Uso

note that, after a fault has occurred, the back and neck heating pad can no longer be used for safe-
ty reasons and must be sent to the service address indicated.
3.2 Selecting temperature
The fastest way to heat up the heating pad is to first set the switch to the highest setting. A lower
setting can be selected later if required.
We recommend the lowest temperature setting for extended use of the heating pad.
3.3 Temperature settings
Level: 0 Off
1 Minimum heat
2 Medium heat
3 Maximum heat
3.4 Automatic switch-off function
In heating pads with automatic cutoff, the heat supply stops approximately 90 minutes
after the heating pad is operated. The illuminated display does not go out. To operate
the heating pad again, you must first set the switch to the "0" position. After about 5
seconds, it can be switched on again. If the heating pad is not used after it has cut off
automatically, it should be switched off ("0" position) or unplugged from the socket.

4. Cleaning and Care

• Before cleaning the heating pad, always unplug it from the mains.
• The textile cover can be cleaned according to the symbols on the label, and for this purpose must
first be removed.
• Please note that the actual heating pad may not be machine-washed, spun or machine d ried,
chemically cleaned, wrung out, pressed or ironed.
• Smaller stains can be removed using a cloth or moist sponge together with a little liquid detergent
for delicate fabrics if necessary.
• Only use the heating pad again once the heating pad and cover are completely dry.
5. Storage
If you are not going to use the heating pad for some time, we recommend storing it in its original
packaging in a dry place without weighing it down.
Allow the heating pad to cool down beforehand.
6. Disposal
Please dispose of the blanket in accordance with the directive 2002/96/EG – WEEE (Waste
Electrical and Electronic Equipment). If you have any queries, please refer to the local aut-
horities responsible for waste disposal.
7
90
min
STOP