Domo DO486BL Manual De Instrucciones página 43

www.domo-elektro.be
could result in the device not working as well as before.
NOTE SURROUNDING USAGE
• Never use the device in the following situations:
• When the jar hasn't been correctly placed on the motor unit.
• When the control knob has selected a speed setting before the jar has
been placed correctly onto the motor unit.
• When the jar has been taken off the motor unit and simply put back in
place. You are required to first turn the control knob in its OFF position
before placing the jar correctly on the motor unit. Only then will the
blender be safe for use.
• When the motor is turning slowly and the food's consistency is too thick or
there's not enough fluid present in the jar, the motor will get too hot when used
for a long while. This could trigger the overheat protection. The red LED light
will blink. Should this happen, you need to remove the plug from the socket
carefully and let the device cool off for about 45 minutes. Afterwards you can use
the device again.
• When blending hot beverages like soups or sauces, we advise you to start at a low
speed setting and gradually increase the speed, or to use the pulse function.
• First start by adding liquids or soft foods before adding the hard foods or ice
cubes.
• When you are done with blending, wait until the blades have entirely stopped
turning before removing the jar from the motor unit. If you do not, the motor unit
might end up damaged.
• If you smell something burnt, immediately stop the device. The rubber on the
motor unit might be the cause, if it was not installed properly
• When using thick or sticky foods at high speeds, you are best to start at a low
speed setting. When the food does not seem to move, pull the plug from the
socket carefully and use a spatula to manually stir the food around until the air
vacuum is no more. Afterwards close the lid and try to blend again.
• Please do not use the device for longer than 10 minutes uninterrupted.
43
DO486BL