Turning The Power On; Changing Between Input Terminals - Sharp LL-T2015 Manual De Funcionamiento

Connecting the monitor and turning the monitor on and off

Turning the power on

1. Turn on the main power of the monitor.
- When switching the main power switch on and
off, always wait for an interval of at least 5
seconds. Rapid switching may result in
malfunction.
2. Press the monitor's power button.
The power LED will light up orange.
3. Turn on the computer.
Press power button.
When a signal is input from the computer, the
power LED lights up green, and the screen is
displayed. (After power is turned on, it may take
a little time until the screen is displayed.)
- If the input terminal to which the computer is
connected has not been selected, the screen
will not be displayed. If necessary, perform
input terminal switching. (right column)
Notes:
- When using an analog signal, perform an
automatic screen adjustment under the following
conditions (p.20):
- Using the monitor for the first time.
- After having changed the system settings
during use.
- Depending on the type of computer or OS, you
may need to install the monitor set-up
information on your system. (p.33)
- When connecting to a notebook, if the notebook
computer's screen is set to display at the same
time, the MS-DOS screen may not display
properly. In this case, change the setting to
display only the LCD monitor.
Main power switch
Turn on the
computer power
supply.
ON
16

Changing between input terminals

Use the INPUT button to switch between signal
input terminals.
When not using a 2-input cable
Analog RGB input terminal
INPUT
INPUT-1
<ANALOG>
When using a 2-input cable
Analog RGB input terminal
INPUT-1
<ANALOG>
INPUT
DVI-I input terminal
(analog)
INPUT
INPUT2-A
<ANALOG>
Note:
- When there is no input signal, [NO SIGNAL] is
displayed.
DVI-I input terminal
INPUT-2
< >
<ANALOG> or <DIGITAL>
INPUT
DVI-I input terminal
(digital)
INPUT2-D
<DIGITAL>