End Of Life - STERWINS 40VPS2-24.1 Instrucciones De Montaje

Problems
Product does
Power/speed switch is in the
not start
Battery pack not properly
On/off switch not set on ON
Chain brake is activated
Battery pack capacity too
Product does
not reach full
power
Vibration
or noise is
saw chain is dull/damaged
excessive
Result is
unsatisfactory
saw chain not tensioned
Battery pack discharged
Product
suddenly stops
*Over current means "Self-protection". "Self-protection" mode is a degraded mode, limited in time (we
recommend a maximum duration of 5 minutes) during which the use of the product is made impossible
so that the product can recover its initial state.

9. END OF LIFE

Electrical products should not be discarded with household products. Used electrical products
must be collected separately and disposed of at collection points provided for this purpose.
Talk with your local authorities or dealer for advice on recycling.
Probable causes
Battery is not secure
Battery is not charged
OFF position
attached
position
low
Air vents are blocked
Bolts/nuts are loose
Blunt saw chain
properly
Battery too hot
Product maybe over
current*
Solutions
To secure the battery pack,
make sure the latches on the
top of the battery pack snap
into place
Charge the battery pack
according to the instructions
included with your model
Press the on/off switch
Attach properly
Refer to chapter "Switching
on/off t"
Disengage the chain brake
(see section "Kickback brake")
Charge battery pack
Clean the air vents
Tighten bolts/nuts
Have it replaced with a new
one
Sharpen or re-place the saw
chain
Tension it properly
Remove and charge battery
pack
Remove battery pack and let it
cool down
Stop the product and wait for
3 minutes to restart
361
Qualifi cation
required
-
-
-
-
-
-
-
-
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
BR
EN