SpeedEPart Agri-Fab 45-0329 Manual Del Usuario página 6

9. Assemble a spacer (Q), a 1-5/8" flat washer (L), a
wheel (air valve facing out) and another 1-5/8" flat
washer (L) onto the end of the axle that has both the
large and small holes. See figure 4.
10. Install a 1/8" x 1-1/2" cotter pin (N) into the small hole
in the end of the axle. See figure 4.
11. Open the bail on the drive pin (W) and install it
through the wheel and the large hole in the axle.
Close the bail to lock the pin in place. See figure 4.
(W) DRIVE PIN
(N) 1/8" x 1-1/2"
COTTER PIN
AIR VALVE
(L) 1-5/8" DIA.
FLAT WASHER
FIGURE 4
12. Turn the spreader upright on its wheels.
13. Assemble the flow control mounting tube to the hitch
tube using two 5/16" x 1-3/4" hex bolts (A), 5/16" lock
washers (l) and 5/16" hex lock nuts (G). DO NOT
TIGHTEN YET. See figure 5.
14. Assemble the vinyl cap (T) onto the flow control
mounting tube. See figure 5.
(T) VINYL CAP
(A) 5/16" x 1-3/4"
HEX BOLT
FIGURE 5
(Q) SPACER
(I) 5/16" LOCK
WASHER
(G) 5/16" HEX
LOCK NUT
ENGLISH
15. Assemble the flow control mounting bracket and the
tube support strap to the flow control mounting tube
using two 5/16" x 1-3/4" hex bolts (A), four 5/16"
washers (K), two 5/16" lock washers (I) and two 5/16"
hex lock nuts (G). DO NOT TIGHTEN YET. See
figure 6.
16. Remove the preassembled bolt and nut from the front
of the hopper. Attach the tube support strap to the
hopper and hopper strap using the bolt and nut you
removed. TIGHTEN. See figure 6.
TUBE
SUPPORT
STRAP
(I) 5/16" LOCK
WASHER
(G) 5/16" HEX
LOCK NUT
FIGURE 6
17. TIGHTEN the two bolts which fasten the flow control
mounting tube to the hitch tube. DO NOT TIGHTEN
the two bolts which fasten the flow control mounting
bracket to the flow control mounting tube.
6
PREASSEMBLED
BOLT AND NUT
HOPPER
STRAP
(K) 5/16"
FLAT WASHER
(A) 5/16" x 1-3/4"
HEX BOLT