Storage, Transport, Disposal; Technical Specifications - Franklin Electric 262 Serie Manual De Instrucciones

Rewindable Submersible Motors

3 Storage, Transport, Disposal

3 Storage, Transport, Disposal
Storage
Transport
DANGER
Unpacking
DANGER
Disposal
4

Technical specifications

Description
Performance/model number
Winding insulation
Voltage range
Voltage tolerance
(on the motor terminals)
Frequency tolerance
Speed
Start alternatives
4
Store the motor in its original packaging until the time of installing it.
If the motor is stored standing up, make sure that it cannot topple over (shaft always pointing up!).
Do not store the motor in direct sunlight or within the reach of other heat sources.
Observe the storage temperature (-15 - +60°C, see technical specifications).
Falling loads may cause lethal injuries or may crush parts of the body!
Nobody is allowed to be located under suspended loads.
Only use approved hoisting gear.
Select the hoisting gear on the basis of the total weight to be transported.
After unpacking the motor check it for possible damage, e.g. damage to the diaphragm cover, housing,
endbell, connection and motor cable.
Immediately inform the supplier of any damage found.
Danger to life due to electrocution if the motor cable is damaged!
Do not install the motor and do not put it into operation.
In order to avoid environmental damage:
Avoid contamination by lubricants, detergents etc.
Dispose of the motor and the packaging material in a proper, environmentally sound manner.
Observe local regulations.
Value
6": 4 - 37 kW
8": 30 - 93 kW
10": 85 - 185 kW
12": 185 – 400 kW
Standard: PVC
Optional: PE2/PA (12 inch Standard)
220 V ... 1000 V, 3~ 50/60 Hz
50Hz: -10 to +6 % of U
60Hz: ± 10% of U
± 2%
approx. 2900 rpm at 50 Hz
Direct starting, wye-delta-starting
, i.e. at a nominal voltage of 380-415 V:
N
380 V –10 % = 342 V / 415 V + 6 % = 440 V
N
models 262 ...
models 263 ...
models 264 ...
models 265 ...