Installing And Connecting Components - Schluter Systems LIPROTEC-EASY Manual De Instrucciones

LIPROTEC-P Operating Instructions

4.3 Installing and connecting components

Fastening the power supply
Personnel
Protective equipment
Tool
Consumable
The power supply must be fixed in its intended position to ensure that the power supply does
not slip out of place and pull on the connection cables, for example. The power supply and
Bluetooth receiver should always be installed in such a way that access is possible without
any difficulty if necessary (e.g. for maintenance or exchange).
1. Screw the power supply onto the mounting surface »
> The power supply is fixed in its intended position and cannot slip out of place.
Laying cables
Personnel
Protective equipment
Tool
We recommend laying cables and distributors in ceilings, cavities, or empty conduits. The
laying of the cables must be planned in such a way that the intended positions are reached
with the specified cable lengths.
1. Lay the cable from the power supply or Bluetooth receiver to the intended connection
points of the LED tubes.
2. Use 2-way or 4-way distributors if necessary.
> A connector plug is positioned at all the connection points intended for the LED
tubes. The connector plug is electrically connected to the power supply by means of
a cable or distributor.
Using a cavity wall socket with sealing collar
Personnel
Protective equipment
Tool
Consumable
Tiler
Protective gloves, safety shoes
Screwdriver, (impact) drill
Fastening screws, 2 dowels if necessary
Tiler
Depending on the installation situation
Depending on the installation situation
Tiler
Depending on the installation situation
Depending on the installation situation
Cavity wall socket with sealing collar, 2 cable
ties
4
.
EN
53