Teaching The Radio Remote Controls - Schluter Systems LIPROTEC-EASY Manual De Instrucciones

Operation via Schlüter
Activating Bluetooth pairing on the Bluetooth receiver
To make it possible for the Bluetooth receiver to establish a Bluetooth connection with a
mobile device (Bluetooth pairing), the pairing readiness needs to be activated via the ra-
dio remote control. If the Bluetooth receiver is to be controlled using a mobile device, the
Schlüter -LED-Color-Control app needs to be installed » "Schlüter
®
" on page 51 .
1. Ensure that the power supply and Bluetooth receiver are connected via plug connectors
as described.
2. Plug the mains cable of the power supply into the intended socket.
3. Ensure that the Schlüter
ifications of the device manufacturer.
4. Press and hold the ON/OFF and UP buttons on the radio remote control at the same time
for approx. 3 seconds »
> The status LED of the Bluetooth receiver flashes blue. The Bluetooth receiver is now
ready to establish a Bluetooth connection for 90 seconds.
5. Establish a Bluetooth connection between the mobile device and the Bluetooth receiver in
accordance with the specifications of the device manufacturer »
> The mobile device and the Bluetooth receiver are now connected via Bluetooth. The
LIPROTEC-EASY system can now be controlled via the Schlüter
app.

5.4 Teaching the radio remote controls

The radio remote control included in the delivery has already been taught in delivery state.
In order for the Bluetooth receiver to be controlled via additional radio remote controls, such
controls first need to be taught. Even if the radio remote control included in the delivery loses
its connection, it can be taught again in the manner described below.
1. Disconnect the voltage supply of the power supply. Unplug the mains cable to this end.
2. Ensure that the power supply and Bluetooth receiver are connected via plug connectors
as described.
3. Plug the mains cable of the power supply into the intended socket.
60
-LED-Color-Control
®
-LED-Color-Control app is installed in accordance with the spec-
®
15
.
WARNING!
It is imperative that the instructions in the Schlüter
app be followed!
NOTE
If step 4 described below is carried out more than once, all previously
taught radio remote controls lose their connection.
– Only carry out step 4 once per radio remote control.
-LED-Color-Control »
®
16
.
-LED-Color-Control
®
-LED-Color-Control
®
2