Triton T12 DD Instrucciones De Uso página 8

Drilling metal
• Support thin material with a piece of scrap wood
• Mark the intended hole position using a hammer and centre punch
• Use only HSS (High Speed Steel) drill bits or others recommended for drilling into metal
• Prior to drilling large holes use a smaller bit to drill a pilot hole
• Use a suitable lubricant to prolong the service life of the drill bit and produce good results
Accessories
A full range of accessories and products is available from your Triton stockist.
• T12B – T12 1.5Ah Li-Ion Battery 12V
• T12HCB – Hi-Cap Battery 3.0Ah 12V
Additional Triton products compatible with the included batteries:
• T12CH – T12 Combi Hammer Drill 12V
• T12AD – T12 Angle Drill 12V
• T12ID – T12 Impact Driver 12V
• T12RS – T12 Reciprocating Saw 12V
• T12OT – T12 Oscillating Multi-Tool 12V
• T12FL – 12V Swivel Head Torch
GB
8
Maintenance
Cleaning
• Keep your machine clean at all times. Dirt and dust will cause internal parts to wear
quickly and shorten the machine's service life.
• Clean the body of your machine with a soft brush or dry cloth.
• If available, use clean, dry, compressed air to blow through the ventilation holes
Storage
• Store this tool and accessories in its case if supplied or a dry, secure place out of the
reach of children
• Always remove the battery before storing this tool
• If storing for an extended period of time, store the battery at full-charge, separate from the
tool, and ensure the battery is recharged every 3 months
Disposal
• Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE),
with household waste
• Contact your local waste disposal authority for information on the correct way to dispose
of power tools