Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

- When switching Off the collar: a series of close sound beeps are emitted
Prepare to replace the battery.
When the battery is too weak, the product works under safety mode, which means that it is out of use.
You need to replace the battery by a new battery of the same type (3 volts CR 2450 lithium battery). Do
as follows:
- Remove the 2 screws from the battery cover using a screwdriver.
- Remove the battery cover.
- Knock out the dry battery by using the supplied magnet (magnetic key) or by tapping briefly the case
in the palm of your hand.
- Insert the new battery paying attention to the polarity indicated under the battery holder (See
Diagram 2).
- A sound beep is emitted indicating that the battery was properly inserted.
If you do not hear any sound beep after inserting the battery, immediately remove it from the battery
holder by using the supplied magnet (magnetic key) or by tapping briefly the case in the palm of your
hand. Check the polarity before inserting the battery once again. If you still do not hear any sound beep,
check the operation by switching the collar On and Off.
- Replace the battery cover taking care to insert first the little pin at the bottom of the battery cover
(See diagram 3).
- Retighten moderately the 2 screws.
NUM'AXES advises to use the same type and same brand of batteries as those supplied in your new
purchased product. Other brands of batteries may not operate, or may not be completely compatible
with your product.
You can purchase the suitable batteries from NUM'AXES or from your distributor.
Changing the sensor
Two different length sensors are included in the package. The size should be long enough to have
proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long haired dog and the short sensor fitted to the collar in the factory is inadequate,
remove the short sensor and replace it with the long one supplied with the kit.
When changing the sensor, do not press on the threaded rod, it could damage the components
underneath. A moderate manual screwing is sufficient (do not use any key). If you screw the sensor
too much, bark detection is likely to be inefficient.

Fitting the collar

The strap should be adjusted so that the sensor comes right into contact with the dog's skin in order
to ensure good barking detection.
Gb - 15

Publicidad

Tabla de contenido
loading

Tabla de contenido