Bosch GTA10W Instrucciones De Funcionamiento Y Seguridad página 3

BM 2610019165 10-11:BM 2610019165 10-11.qxp 10/13/11 7:50 AM Page 3
STAND SeT-UP
To avoid serious injury when
CAUTION
lifting the saw, bend your
knees and lift with your legs, not with your
back.
The saw can be placed on a flat surface for
cutting operations without using the stand
(Fig. 1).
FIG. 1
When using the stand, observe the following
instructions:
To oPeN The STAND:
1. Place the folded stand on a flat surface,
(Fig 2).
2. Pull out the red lock knob, then lift the
handle (Fig. 2).
FIG. 2
3. Continuing to lift the handle, pull the
crossbar out until you hear the legs lock in
place (Fig. 3).
Assembly
FIG. 3
4. On the opposite end of the stand, locate
the handle and the red lock sleeve on the
crossbar, and note the arrow on the lock
sleeve. Lift the handle and move the lock
sleeve in the direction of the arrow on the
sleeve. Allow the legs to fall, and then
release the sleeve (Fig. 4).
FIG. 4
Hold the lift handle, and pull the lower
crossbar until you hear the legs lock into
place.
5. Tighten the locking nut (Fig 5). Make sure
all connections are firm and the stand is
steady.
-3-