Bosch GTA10W Instrucciones De Funcionamiento Y Seguridad página 4

BM 2610019165 10-11:BM 2610019165 10-11.qxp 10/13/11 7:50 AM Page 4
FIG. 5
6. The stand anchors located on the two
shorter legs (Fig. 6) may be used to attach
the stand to the floor with screws (not
supplied).
FIG. 6
CloSINg The STAND
From the side of the stand with two wheels,
first pull out the red knob at the end of the
crossbar, as shown in Fig. 7, then reverse
the steps described in "To Open the Stand."
FIG. 7
MoUNTINg TIle SAw
Before mounting the saw
WARNING
on the stand, make sure the
stand is fully opened, all locking nuts are
tightened, all locking pins are engaged,
both wheel are locked (Fig. 8)
LOCKING NUT
ANCHORS
-4-
• Place stand on flat, level surface.
• Turn tool switch off and unplug power
cord to disconnect tool power.
• empty water from tile saw water tray by
following "Filling and Draning the water
Tray" instructions in Bosch TC10 manual.
• Prepare Bosch TC10 wet Tile and Stone
Saw for mounting
"Transporting and Mounting" instructions
in Bosch TC10 manual.
Before mounting the saw on the stand, make
sure that both wheels on the stand are
locked (Fig. 8).
FIG. 8
Place the saw on the stand. Make sure that
the motor housing is positioned above the
wheels. Also make sure the saw fits within
the four retaining walls located on the stand.
In doing so, the four mounting holes within
the saw base should be aligned with the four
corresponding holes on the stand table (Fig. 9).
FIG. 9
by following