Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
C ) EXTERNAL SPEAKER JACK (8 Ω Ω Ω Ω Ω , Ø 3,5 mm)
C) TECHNICAL CHARACTERISTICS:
1) GENERAL:
- Channels
- Modulation modes
- Frequency ranges
- Antenna impedance
- Power supply
- Dimensions (in mm)
- Weight
- Accessories supplied
2) TRANSMISSION:
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Emitted power in the adj. channel :
- Microphone sensitivity
- Drain
- Modulated signal distortion
3) RECEPTION:
- Maxi. sensitivity at 20 dB sinad
- Frequency response
- Adjacent channel selectivity
- Maximum audio power
- Squelch sensitivity
:
40
:
AM/FM
:
from 26.965 MHz to 27.405 MHz
:
50 ohms
:
13.2 V
:
150 (L) x 170 (H) x 45 (D)
:
1.2 kg
:
UP/DOWN microphone with
support, mounting cradle, screws.
:
+/- 100 Hz
:
1 W AM / 4 W FM
:
inferior to 4 nW (- 54 dBm)
:
300 Hz à 3 kHz
inferior to 20 µW
:
1,0 mV
:
1,7 A (with modulation)
:
1,8 %
:
0.5 µV - 113 dBm (AM/FM)
:
300 Hz à 3 kHz
:
60 dB
:
2 W
:
minimum 0.2 µV - 120 dBm
- Frequency image rejection rate
- Intermediate frequency rej. rate
- Drain
mum
D) TROUBLE SHOOTING:
1) YOUR CB RADIO WILL NOT TRANSMIT OR YOUR
TRANSMISSION IS OF POOR QUALITY:
- Check that the antenna is correctly connected and that the SWR is properly
adjusted.
- Check that the microphone is properly plugged in.
- With the «push-to-talk» switch activated, the display flashes. Release the
«push-to-talk» switch, then re-press it to go into transmission.
2) YOUR CB RADIO WILL NOT RECEIVE OR RECEPTION IS POOR:
- Check that the squelch level is properly adjusted.
- Check that the volume is set to a comfortable listening level.
- Check that the microphone is properly plugged in.
- Check that the antenna is correctly connected and that the SWR is properly
adjusted.
- Check that you are using the same modulation mode as your correspondent.
3) YOUR CB WILL NOT LIGHT UP:
- Check the power supply.
- Check the connection wiring.
- Check the fuse.
E) HOW TO TRANSMIT OR RECEIVE A MESSAGE:
Now that you have read the manual, make sure that your CB Radio is ready
for use (i.e. check that your antenna is connected).
Choose your channel (19, 27).
Choose your mode (AM/FM) which must be the same as that of your
correspondent.
Press the «push-to-talk» switch and announce your message «Attention
32
maximum 1 mV - 47 dBm
:
60 dB
:
70 dB
:
550 mA nominal / 1500 mA maxi-
Publicidad
Tabla de contenido
