GAS CONVERSION
Tools and Parts for Gas Conversion
Gather the required tools and parts before starting
installation. Read and follow the instructions provided with
any tools listed here.
Tools needed
Phillip screwdriver
Pipe Wrench
Adjustable wrench
6 mm socket and
wrench or 6 mm nut
driver
Parts supplied
Natural gas orifice for sear burner
Parts needed
Natural gas conversion kit Part Number 710-0003. See
"Assistance" section to order. The conversion kit includes:
Natural gas regulator 4" W.C. (marked "Natural Gas
Regulator )
Regulator")
10 ft (3.0 m) Natural gas hose with quick connector
5.9" (150 mm) Natural gas regulator hose
6 mm nut driver
6 mm wrench
Hex key
IMPORTANT: Gas conversions must be done by a qualified
installer. Before proceeding with conversion, shut off the gas
supply to the appliance prior to disconnecting the electrical
power.
20
p
Thin 6" flat-blade
screwdriver
Pliers
Pipe thread sealant
certified for LP gas
Conversion from LP Gas to Natural Gas
Installation of the regulator
1.
Turn off all burner control valves.
2.
Turn off the main gas supply valve.
3.
3
Di
Disconnect 20 lb LP gas fuel tank (if present).
t 20 lb LP
4.
Remove the 20 lb LP gas fuel tank (if present) from the grill
cart.
5.
Use an adjustable wrench to remove the LP regulator from
the manifold.
6.
Use an adjustable wrench to install the Natural gas
regulator hose to the manifold and secure. Attach
the Natural gas regulator to the side panel inside
the grill cart with the two screws that are pre-
th
ill
t ith th t
assembled on the regulator.
f
l t
k (if
t)
th t