KitchenAid 720-0787D Manual De Uso página 30

Asador autónomo para exteriores
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BURNERS
Cleaning Method:
 Clean the exterior of the burner with a wire brush.
 Clear any clogged burner ports with a
straightened paper clip
 Do not use a toothpick as it may break off and
clog the port.
clog the port
 Check and clean burner/venturi tubes.
1.
Remove grill grates and flame tamers.
2.
Remove the screw and cotter pin that hold the burner in
place. Remove gas burner from the grill.
B
A.
Cotter pin
B. Screw
3.
Use a flashlight to inspect the burner inlet to ensure there
is no blockage. If any obstruction is seen, use a metal
coat hanger that has been straightened to clear them.
4.
After inspecting the inside of burner for blockage,
reassemble burner by sliding the middle tube of the gas
bl b
burner over the gas orifice.
A
A. Burner/orifice connection
A Burner/orifice connection
5.
Reattach gas burner using screw.
30
b
lidi
th
iddl t b
ROTISSERIE BURNERS
Cleaning Method:
1.
Light the rotisserie burner. See the "Using Your Rotisserie
Burner" section.
2.
Close the grill hood.
3.
3
Leave the burner on high for approximately 30 minutes
Leave the burner on high for approximately 30 minutes.
4.
Turn knob to OFF and let cool completely.
5.
Brush off ash particles from the rotisserie burner.
IMPORTANT: The grease box should only be removed when
grill is completely cool.
The full-width grease box collects grease and food particles
that fall through the grill. Clean often to avoid grease buildup.
Cl
Cleaning Method:
i
M h d
 Remove grease box and set on a flat surface.
 Wipe excess grease with paper towels.
A
 Mild detergent and warm water. Rinse and dry
thoroughly.
 Replace grease box.
KNOBS AND FLANGE AREA AROUND KNOBS
IMPORTANT: To avoid damage to knobs or flange area
IMPORTANT T
around knobs, do not use steel wool, abrasive cleaners, or
oven cleaner.
Do not soak knobs.
Cleaning Method:
 Mild detergent, a soft cloth and warm water.
 Rinse and dry.
CONTROL PANEL GRAPHICS
f th
IMPORTANT: To avoid damage to control panel graphics, do
not use steel wool, abrasive cleaners or oven cleaner.
Do not spray cleaner directly onto panel.
Cleaning Method:
Clean around the burner labels gently; scrubbing may
remove printing.
Mild detergent, soft cloth and warm water.
Rinse and dry.
id d
k
b
y
fl

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

730-0787d

Tabla de contenido