Maintenance; Warranty - SPARKY BR 60E Instrucciones De Uso

to clockwise rotation, the extreme position to the left – to
anti-clockwise rotation. When the ON/OFF switch (8) is
depressed lever (6) can not be actuated. Reversing can
be performed only when the spindle is not rotating!
SCREWING / UNSCREWING BOLTS,
SCREWS AND NUTS
Following the above-described procedure, tighten the
corresponding accessory in chuck (2). Select the rota-
tion direction necessary by lever (6). These operations
must be performed only at low rpm.
WARNING: In case of screwing / unscrewing
long bolts and screws there is a danger of slipping the drill.
REMOVING THE CHUCK
Grip rear collar of keyless chuck (2) and rotate front collar
until chuck is opened. By means a screwdriver unwind the
left-treaded securing screw. Insert and fasten Allen key or
screwdriver bit into the chuck.
Clamp the place for fixing the spindle (3) by means of a
spanner and rotate the chuck anti-clockwise by the free end
of the key (bit).
RECOMMENDATIONS FOR OPERATION
Drill at speed lower than the maximum speed and select the
speed depending on the processed material.
Use straight shank drill bits.
Watch out the stage of blunting of the bit and replace it if
considerable decrease of efficiency is observed.
Before drilling large-diameter holes in metal, wood or plas-
tics, drill a small pilot hole.
ACCESSORIES TO BE USED WITH
THIS POWER TOOL
▪ Drill bits for metal Ø0.8 to Ø6 mm.
▪ Drill bits for wood Ø0.8 to Ø13 mm.
▪ 6.35 mm (1/4") hexagon shank screwdriver bits.

Maintenance

WARNING: Always ensure that the tool is
switched off and unplugged before attempting to perform
inspection or maintenance.
BRUSH REPLACEMENT
When the carbon brushes are worn out, both brushes
must be replaced simultaneously with genuine brushes at
SPARKY service centre for warranty and post-warranty
service.
CLEANING
For safe operation always keep the machine and its ventila-
tion slots (5) clean.
6
EN
With the motor running, blow dirt and dust out of all air
vents with dry air at least once a week. Wear safety
glasses while performing this.
Exterior plastic parts may be cleaned with a damp cloth
and mild detergent.
WARNING: Although exterior plastic parts are
highly solvent resistant, never use solvents!
IMPORTANT! To assure product safety and reliability,
repairs, maintenance and adjustment (including brush
inspection and replacement) should be performed by
certified service centres or other qualified service or-
ganisations, always using genuine replacement parts.

Warranty

The guarantee period for SPARKY power tools is deter-
mined in the guarantee card.
Faults due to normal wear, overloading or improper han-
dling will be excluded from the guarantee.
Faults due to defective materials implemented as well as
defects in workmanship will be corrected free of charge
through replacement or repair.
The complaints for defective SPARKY power tools will
be recognized if the machine is sent back to the dealer
or is presented to the authorised warranty service centre
undismantled, in its initial condition.
Notes
Carefully read the entire original instructions before us-
ing this product.
The manufacturer reserves the right to make changes
and improvements to the products and to alter specifica-
tions without prior notice.
Specifications may differ from country to country.
BR 60E • BR 65E