Status Lights, Signal And Reversing; Drying Laundry - Alliance Laundry Systems JT30XG Manual De Instalación, Operación, Mantenimiento Y Seguridad

STATUS LIGHTS, SIGNAL AND
REVERSING
DOOR OPEN Lights when door is open.
Note: Display window also flashes.
DRYING Lights when laundry is drying.
COOL DOWN Lights when laundry is cooling.
CUSTOM Lights when a Custom cycle is pro-
grammed, recalled or running.
SIGNAL When lit, the signal will sound when
the laundry is ready for removal.
The signal has three loudness levels.
These can be set anytime the control
is activated. Pressing the SIGNAL
pad once produces the softest tone.
Additional presses produce louder
tones. The fourth press turns tone
and light off. The loudness level
selected is for all cycles until
changed.
When the signal is on and any key
pad is pressed, it sounds at the
selected level to confirm the pad was
properly pressed.
REVERSING When lit, the cylinder will rotate
(For Reversing in one direction for 25 seconds,
Models only) pause for 6 seconds, then rotate in
opposite direction for 25 seconds.
This sequence will repeat until the
selected cycle ends. To turn Revers-
ing option off, press the REVERS-
ING pad. (Any time reversing pad is
pressed, the cylinder will pause for 6
seconds.)
STATUS Lights
Figure 26
56
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

DRYING LAUNDRY

1. LOAD TUMBLER –
Open loading door. Shake out laundry and place in
tumbler.
2. CLOSE DOOR –
Tumbler will not operate with open door.
WARNING
To reduce the risk of bodily injury, the
tumbler stops tumbling when the door is
opened. Do not use the tumbler if it does
not stop tumbling when the door is
opened or starts tumbling without
pressing the START pad. Remove the
tumbler from use and call for service.
NOTE: Do not press directly on lights or the center of
pad. For proper selection, press on pad slightly to the
right of center.
W078
M414545