How To Attach The Electrode Pads; Examples Of Application - Omron E2 ELITE Manual De Instrucciones

Neuroestimulador electrónico
Ocultar thumbs Ver también para E2 ELITE:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 66
HV-F127 manual.book Page 9 Monday, December 29, 2014 3:34 PM

2.3 How to attach the electrode pads

Attach each Pad to the region you want to treat without
bending it.
When using the unit for the first time
A clear plastic film is attached to the
Pads.
As the Pads have strong adhesive-
ness, peel off the clear plastic film
from the Pads and attach the Pads
to the region you want to receive
treatment.
* Discard the peeled off clear film
as it should not be used anymore.
* It may be difficult for you to attach
the Pads on your back such as
shoulders or lower back. It is a good
idea to ask someone to help you.

2.4 Examples of application

Shoulders
Stiff shoulders are presumably caused by blood congestion of
trapezius muscle that moves shoulders, compression of
nerves by the accumulation of fatigue substances, or poor
blood circulation of subcutaneous tissues such as muscles.
Attach the Pads symmetrically on the region of stiff shoulders
with the backbone as the center.
Trapezius muscle
For stiff shoulders,
it is effective to
attach the Pads to
the shaded regions
as shown in the
diagram.
Attach the Pads close to the skin.
* If the Pads comes off from the skin, the unit is turned
off automatically in approximately 7 seconds.
General Advice from OMRON on the handling of Pads
• Do not place pads stacked on each other.
• Do not bend the Pads.
• Do not touch the adhesive surface with your fingers.
• When you perspire after taking a bath or immediately
after exercising, wipe your sweat off the region you want
to treat before using the unit.
• If a Pad attaches to cloth or other material and does not
come off easily, do not force it off. Instead, moisten the
back of the cloth to which the Pad is attached with a
small amount of water, and then the Pad will come off
easily.
• When the adhesive property of Pad drops, take appropri-
ate measures as necessary.
• If you are going to use a wet Pad (see Section 3, Mainte-
nance) or the Pad immediately after it is washed, let it dry
sufficiently. Especially let the adhesive surface air-dry.
Sole
Chilly feeling is presumably caused by poor blood circulation
in the limbs when the nerves are out of balance.
Swelling and fatigue of feet is presumably caused by the poor
reflux of blood and body fluid. Attach one Pad to the sole and
another one to the calf.
It is effective to
attach the Pads
to the shaded
regions of sole
as shown in the
diagram.
2.How to use the device
EN
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hv-f127-e

Tabla de contenido