Cleaning And Maintenance - Domo DO8146 Manual De Instrucciones

4. Fasten the small turn screw (D) on the unit.
5. To mount the grill, position the back of the grill on the base. Make sure the handle is
located at the top. Fasten the back of the grill with 4 small black screws.
6. To fasten the fan blades to the fan, turn the protruding pin so that the flat side is up.
Fasten the fan blades with a screw.
7. Finally, mount the front of the grill on the fan. Make sure that the clip is at the top and
the opening for the screw is at the bottom. Position the screw in the opening provided
and tighten it with the nut at the back, so that the front and back of the grill fit together
correctly. Fasten the halves of the grill together with the clips.
USE
Put the plug in the socket. The button for the speed settings allows
you to turn the fan on and off. There are 3 speeds to choose from (low -
medium - high). To switch the appliance off again, turn the button back
to 0.
OSCILLATION
To allow the fan to oscillate, push in the oscillation button. To stop the fan from oscillating,
pull the button up. When it is switched on, it will alternately turn to left and right to better
spread the air.
DIRECTING THE AIR FLOW
To direct the air flow up or down, loosen the knob for tilting the grill to adjust the direction up
or down. Once the fan is pointed in the right direction, tighten the knob again.
ADJUSTING THE HEIGHT
The height of the fan can be adjusted by loosening the knob and lengthening or shortening
the telescopic tube. Then tighten the knob again. The blocking ring on the tube ensures that
the fan cannot be lowered too far, which would cause the rotation of the fan to be blocked.

CLEANING AND MAINTENANCE

· This fan requires very little maintenance. Never try to repair the fan yourself. If it is
defective, have it checked and/or repaired by a qualified person.
· Prior to assembling the fan or cleaning it, remove the plug from the outlet.
· Keep the rear grill free of dust and other substances in order to allow free circulation of the
air around the motor. Do not disassemble the fan to remove dust from the motor.
· You may clean the exterior of the machine with a soft moist cloth and a mild detergent.
Carefully dry the machine afterwards.
· Never use corrosive or abrasive products to clean the machine.
· Make sure that no water gets into the motor of the machine.
24
DO8146