Switching Mymodes Using The Remote Control Unit; Changing Prosthesis Settings - Ottobock 4X350 Instrucciones De Uso

8.1.1 Switching MyModes using the remote control unit

INFORMATION
When the menu option "Mode" has the
the remote control unit, it means that MyMode settings cannot be retrieved.
Once a connection to a prosthesis has been established, the remote control
can be used to switch between modes.
9
1) Use the ,
and confirm this with the key.
2) Use the ,
key.
INFORMATION: If the list of modes was called up accidentally, the
active mode can be selected again.
→ A beep signal sounds to confirm the switch. The message "Mod­
eswitch successful" appears on the remote control unit.
If necessary, switch off the remote control unit by selecting the menu option
"RC power off" using the

8.2 Changing prosthesis settings

Once an active connection to a prosthesis has been established, the set­
tings of the MyMode that is currently active can be changed using the
remote control.
Information for changing the prosthesis settings
• Before changing settings, always check the display of the remote control
unit to make sure the correct prosthesis has been selected. Otherwise,
parameters could be changed for the wrong prosthesis.
• It is not possible to change prosthesis settings nor to switch to a differ­
ent mode while the prosthesis battery is being charged. Instead of the
symbol, the symbol appears in the status bar.
• The prosthetist's setting is located in the middle of the scale. After mak­
ing adjustments, you can restore this setting by moving the slider control
into the middle.
10
keys to select the menu option "Mode" in the main menu
keys to select the mode you want and confirm this with the
, keys, and confirm this with the key.
symbol next to it in the display of
11
Ottobock | 31