Programming The Device Code - HP SL4778N Manual De Instrucciones

Programming the device code

Use the following steps to program a device button if
your brand is listed.
Read all the steps completely before
proceeding. Highlight or write down the
codes and device you wish to program
before performing step 4. If your
Manufacturer is not listed in the
"Manufacturer's codes" on page 46, then
try programming the device code using the
steps in "Programming the device code
using auto setup mode" on page 45.
1
Locate the brand of your device and the
manufacturer's codes (see listings in
"Manufacturer's codes" on page 46).
2
Turn on the TV. Turn on the device you would like to
program.
3
Press Device button on the remote control as
needed to select AUD, STB, or AUX to program.
Wait until the device indicator light on the remote
control goes out.
4
Press and hold down the Device button on the
remote control for 5 seconds until the device
indicator light blinks, and then release the Device
button. The device light blinks one more time and
then remains lit, indicating the remote control is in
programming mode.
5
Enter the first four-digit code. If the code is
accepted, the device light flashes twice. If the code
is not accepted, the device light flashes three times.
If the device indicator light did not blink
twice, then repeat steps 4 and 5, entering
either the same code or the next code, if
available.
44
HP MediaSmart HDTV User Guide
n
n
Enter code 9, 9, 9, 9 to reset the selected
■
device to the factory default
manufacturer value.
Enter code 1, 1, 1, 1 to enter auto setup
■
mode; see "Programming the device
code using auto setup mode" on
page 45.
Pressing the 1, 3, and 0 buttons on the
■
remote control at the same time resets all
three programmable devices to factory
values.
6
Aim the remote control at the device, and press the
Power button once. The device should turn off. If it
does not respond, repeat steps 4 and 5, trying
each code for your brand until you find one that
works. If it still does not work, try searching for the
code using auto setup mode; see "Programming
the device code using auto setup mode" on
page 45.
If the device does not have a Power button,
press Play.
7
Repeat steps 1 through 6 for each device you want
to control with the remote control.
!
n