Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION PROCEDURE
INSTALLATION PROCEDURE
SPOUT INSTALLATION
Set Screw
Hex Wrench
NOTE: Thoroughly clean and remove debris from the water supply pipe before installation. This will
prevent clogging the spray outlet.
■ Remove the set screw and slide the pipe connector out from the spout. Take care not to damage
the O-ring.
■ Wrap adequate amount of pipe tape around the thread of the 1/2" NPT nipple. Install the nipple to
the elbow. Make sure the 1/2" NPT nipple extends between 3/8" to 7/8" beyond the finish wall.
■ Wrap pipe tape onto the thread of the other end of the nipple and then thread the pipe connector
onto the nipple. Take care not to damage the O-ring.
■ Slide the spout onto the pipe connector. Take care not to damage the O-ring.
■ Secure the spout with set screw.
4
Pipe Connector with O-ring
Finished
shower wall
1/2" NPT Nipple
3/8"
Pipe connector
to 7/8"
with O-ring
PIECES DE RECHANGE
PIECES DE RECHANGE
N° Description
1 Adaptateur de canalisation avec joint torique
2 Vis de serrage
3 Bec
3 3
2 2
21
1 1
Publicidad
