Measurement Of Voltage Harmonics (Ht4022) - HT Instruments HT4020 Manual De Instrucciones

4.3.3. Measurement of Voltage Harmonics (HT4022)

1. Select the "
2. Press
is displayed
3. Insert the red plug into V/ jack and the black plug COM into jack. For ease of use,
attach the rubber test lead holster and insert a test lead (see Fig. 3)
4. Connect the test leads to the circuit under test (see Fig. 6). The instrument displays the
Total Harmonic Distortion value of the input signal. The symbol "THD%" is shown on
the display. See § 8 for the parameter's definition
5. With the H and H keys you can cycle through all available harmonic values from DC
to the 25
percentage value is displayed on the main one (ex. h3% means third harmonic)
6. Press the
DC to 25
absolute value is displayed on the main one (ex. h3 means third harmonic)
7. Press
(see § 4.3.1)
1.800.561.8187
 The maximum Voltage input is 600V. Do not attempt to take any voltage
measurements exceeding the limits indicated in this manual. Exceeding
the limits could cause electrical shock or damage to the instrument.
 Harmonic voltage measure is active for AC voltage on inputs only.
Fig. 6: Use of instrument for AC voltage harmonic measurement
V
" position
FUNC/HARM key and keep it pressed at least 1 second until symbol "THD%"
th
order. On the secondary display is shown the order of the harmonic whose
FUNC key to switch to the absolute harmonics' values displaying (from
th
order). On the secondary display is shown the order of the harmonic whose
FUNC key to escape this mode going back to voltage measurement function
www.
CAUTION
information@itm.com
.com
EN - 10
HT4020 - HT4022