Making Coffee With Ground Coffee; Dispensing Hot Water - Gaggia TITANIUM Instrucciones De Uso

ENGLISH
the display will indicate (for example)
1 SMALL COFFEE
Dispense 1 coffee, place a single cup beneath the coffee spouts and
press the button (22, 23 or 24) only once; to dispense 2 coffees,
place two cups beneath the coffee spouts and press the button (22,
23 or 24) twice; the display will show:
2 SMALL COFFEES
In this operating mode, the appliance automatically grinds and
doses the right quantity of coffee; making two coffees requires two
grinding and dosing cycles, which are automatically managed by
the machine.
• Then the dispensing cycle starts.
• After undergoing a pre-brewing cycle, coffee will start to come out
of the spout (Fig.01, pos.13).
The coffee will stop flowing automatically when the preset level is
reached (see section 7.3). You can interrupt the flow of coffee by
pressing the button (Fig.01, pos.22 23 or 24).

7.2 Making coffee with ground coffee

In this operating mode, you must use the scoop
provided (Fig.01, pos.21) to measure out the
ground coffee.
Only use ground coffee suitable for espresso coffee
makers in the doser (5); placing coffee beans, instant
coffee and other materials inside the doser causes damage to
the appliance.
Keep fingers away from the ground coffee doser since
there are moving parts.
Use the scoop provided (21) to measure out the right quantity of ground
coffee to place in the doser .
Use only one full measuring scoop at a time; to make two coffees, you
must go through the entire process twice.
• Pressthe button (25) to select the function; the display will show
SELECT PRODUCT
PREGROUND COFFEE
• Lift the cover of the ground coffee doser (Fig.13).
• Fill the scoop with one measure of coffee; discard any excess ground
coffee.
• Fill the doser with the ground coffee (Fig.14)
• Close the cover of the ground coffee doser.
• To dispense coffee, press the coffee dispenser button (22, 23 or 24);
the display will show (for example)
1 SMALL COFFEE
PREGROUND COFFEE
• The dispensing cycle will start.
• After undergoing a pre-brewing cycle, coffee will start to come out
of the spout (13).
The coffee will stop flowing automatically when the preset level is
reached (see section 7.3). You can interrupt the flow of coffee by
pressing the button (22 23 or 24).
• Subsequently the machine will automatically switch back to the
normal operating mode (see section 7.1).
7.3 Adjusting the quantity of coffee per cup
The machine has been programmed to dispense 3 types of coffee:
espresso coffee with button 22, normal coffee with button 23 and
"caffe lungo" with button 24.
To adapt the programmed settings to the size of your cups, place a
cup beneath the coffee spouts (13), press the dispenser button
corresponding to the kind of coffee you want (22, 23 or 24) and
keep it pressed down; the display will show (for example):
1 COFFEE
PROGR. QUANTITY
Wait for the cup to fill to the desired level and release the button.
Note: keep the button (23) or (24) pressed during the
entire coffee dispensing process.
In this way, the appliance is programmed to dispense the quantity of
coffee you selected.
8

DISPENSING HOT WATER

Caution: splashing may occur at the start – scalding
hazard! The hot water nozzle and pipe can reach high
temperatures: avoid touching directly with your hands.
• Before attempting to dispense hot water, make sure that the display
shows.
SELECT PRODUCT
READY FOR USE
When the machine is ready to dispense coffee, carry out the following
steps.
• Press the button (26); the following messages will be
• 30 •