TFA Dostmann LOGO Manual De Instrucciones página 23

3. After the batteries are inserted, the temperature station will start receiving data signal from the
transmitter. The outdoor temperature data should then be displayed on the temperature
station. If this does not happen after 2 minutes, the batteries will need to be removed from
both units and reset from step 1.
4. In order to ensure sufficient 868 MHz transmission however, the distance between the temperature
station and the transmitter should not be more than 100 meters (see notes on "Positioning" and
"868 MHz Reception").
Note:
In the event of changing batteries of the units, ensure the batteries do not spring free from the contacts.
Always wait at least 1 minute after removing the batteries before reinserting, otherwise start up and
transmission problems may occur.
WHEN MORE THAN ONE TRANSMITTER IS USED
1. Remove all the batteries from the temperature station and transmitters, and wait 60 seconds.
2. Insert the batteries in the first transmitter.
3. Within 2 minutes of powering up the first transmitter, insert the batteries in the temperature station.
Once the batteries are in place, all segments of the LCD will light up briefly. Following the indoor
temperature and the time as 0:00 will be displayed. If this information is not displayed on the LCD
after 60 seconds, remove the batteries from both units and wait for at least 60 seconds before
reinserting them.
4. The outdoor temperature data from the first transmitter (channel 1) should then be displayed on the
temperature station. Also, the signal reception icon will be displayed. If this does not happen after 2
minutes, the batteries will need to be removed from both units and reset from step 1.
5. Insert the batteries in the second transmitter as soon as the outdoor temperature readings from the
first transmitter are displayed on the temperature station.
22