Rear Wheel Assembly - Medline MDS86835DSHEC Instrucciones De Usuario

Rear Wheel Assembly

1. Turn wheel so that it is facing outside of walker (see Figure A).
2. Insert wheel to desired height depicted by numeric holes (see Figure B)
and use chart below for recommended height settings.
3. Insert triangular hand screw into hole on same side of wheel so that
the triangular hand screw stays outside of walker frame (see Figure C).
4. Tighten triangular hand screw
(see Figure C).
5. Repeat steps 1-4 for other rear wheel.
Figure A
(Important: Hand Tighten Only!)
Figure B Figure C
Recommended Height:
Your feet should comfortably touch the ground
when you are seated on walker.
Height Range:
Under 5' (152 cm) Hole 1 or 2
5'1"-5'6" (155-170 cm) Hole 3 or 4
5'7" (173 cm) and over Hole 5 or 6
Note: These are only recommended
heights, as each individual is
built differently.
WARNING: Wheels and brake shoes
must be on the outside of the walker.
1-800-MEDLINE (633-5463) | medline.com 7
until secure