Steam Ironing - Sunbeam 3982 Manual De Instrucciones

S I
TEAM RONING
1. Make sure the Steam dial is turned to the Dry/O setting.
2. Follow the instructions for "Filling the Water Reservoir" on Page English-3.
3. Plug the cord into a 120-Volt AC outlet.
4. Turn the large Fabric/Temperature dial to the fabric setting you desire
(Synthetic, Silk, Linen, Cotton or Wool). Allow the iron to heat for 2 minutes.
While the iron is heating, make sure it is sitting on its heel rest on a stable,
protected surface.
5. Allow the iron to heat for 2 minutes and then turn the Steam dial to the
appropriate setting.
T : Refer to the Ironing Guide on Page English-7 for the recommended setting
IP
for your fabric.
H T
OW
S M
®
PRAY IST
The SPRAY MIST ®
fabrics and for setting creases. To use the SPRAY MIST
button (may require several pumps to prime the water pump).
A -O
UTO FF
After 30 minutes, the power indicator light will go out. This indicates that the iron is
no longer heating.
To restart the iron, unplug the power cord and plug it back in. If you do NOT want to iron
any longer, unplug the iron. Then turn the small Steam dial to Dry/O and the
large Fabric/Temperature dial to Off/O.
WARNING: Auto-Off is a safety feature and is not a recommended means for turning
your iron off. See "Caring for Your Iron After Use" on Page English-5.
U
O SE THE
feature dampens the fabric to aid in removing wrinkles from heavy
S
PECIAL
feature: Pump the SPRAY MIST
®
English-4
F
UNCTIONS
®