Sysresult - System Check Result; Tamode - Telco Adapt Mode - ClearOne CONVERGE PRO 880 Manual De Instalación Y Funcionamiento

sysResUlT – System Check Result
This command reports the results of the system check. This command is reportable only. it cannot be queried
or set. The system check integer bits determine which test result will be reported. each test results in a separate
SYSreSulT message.
argument Type
System Hexadecimal
Check integer
Status unsigned
integer
message String
Tamode – Telco Adapt Mode
This command selects/reports the Telco adapt mode.
Command Form: DEVICE Tamode <Channel> [Value]
argument Type
Channel Channel
Group Group
Value unsigned integer
242 Technical Services: 800-283-5936
size values
4 15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
All other bits reserved
2 0 = Fail
1 = pass
2 = null <not Tested or Test disabled in SYSConFiG>
40 For the telephone on hook: the message will report the line
voltage, the line current, other results, and if dial tone is
detected.
For the telephone off hook: the message will report the line
current, other results, and if dial tone is detected.
The bit mask for the other results is
x x x x x x x x
| | | | | | | |--> set if switched from CTr21 to FCC
because of low current
| | | | | | |--> set if used diAl bit while dialing
| | | | | |--> set if switch from low Voltage to Japan
because of current
| | | | |--> set if switch from low Voltage to FCC because
of current
| | | |--> dAA oVl status
| | |--> dAA dod status
| |--> dAA opd status
|--> not used
For the network check: the box will report if no ip address is
set. if it is set, the box will ping the gateway. The message
will say the ping failed if it is not returned in 5 s. otherwise,
the message will report how many seconds it took to return
the ping.
size values
1 See Groups and channels
1 17 (r)
2 0 = Auto
1 = Burst
(null to query in text)
Telephone
mic 1
mic 2
mic 3
mic 4
mic 5
mic 6
mic 7
mic 8
network
Units