TFA Dostmann 30.3012 Manual De Instrucciones página 36

When the clock is trying to receive the DCF signal, the reception icon will flash on the LCD. Once
the signal is "locked", the DCF-77 tower icon will stay fixed on LCD and the received time will
automatically correct the manually set time. As well as the time, the date will also be received by
the Remote Thermo and will be displayed accordingly in the calendar section of the LCD.
Time setting:
After the batteries are inserted, set the time display as follow:
1. Press and hold the "SET" key about 3 seconds to enter the set mode. The Hour digit in the
time section starts flashing
2. Using the "IN" key, enter the hours of the current time and then followed by pressing the
"OUT" key to enter the minutes of the current time.
3. Press the "SET" key to exit the setting mode. Your Remote Thermo is now fully operational.
USING THE REMOTE THERMO:
Indoor temperature:
The indoor temperature is displayed on the second line of the LCD under the time. The Remote
Thermo's built in sensor automatically measures the temperature once the batteries are inserted.
Minimum and maximum indoor temperature recordings:
By pressing the "IN" key the current indoor temperature will alternate between the minimum,
maximum and current temperature recordings. Once a new indoor temperature high or low is
reached, it will automatically set into the Remote Thermo's memory.
Outdoor temperature reading:
The outdoor temperature reading is on the bottom line of the LCD under the indoor temperature.
The Remote Thermo receives the outdoor temperature via 433 MHz frequency when the batteries
are inserted into the transmitter within the 2-1/2 minutes of the setting up time (See Setting up
above).
Note:
Should the outdoor temperature not be received within 2-1/2 minutes after inserting the batteries
into a transmitter, then see "Checking 433 MHz reception" below.
Minimum and maximum outdoor temperature reading:
By pressing the "OUT" key the current indoor and outdoor temperature will alternate between the
minimum, maximum and current temperature recordings. The time when the minimum and
maximum outdoor temperature records were received will be also shown on the LCD blinking