Initiating X-Ray Exposure - VATECH Pax-i3D Manual Del Usuario

3 Acquiring PANO Images
3.3
Exposure indicator
light turns orange
Orange: Exposure
X-Ray ON
38

Initiating X-Ray Exposure

The X-Ray exposure method and its sequences are the same for PANO
Standard and PANO Special modes. The example used in this manual is the
PANO Standard mode.
To emit the X-Ray, perform the following procedure.
-
Do not operate the PC during exposure. Failure to
comply with this instruction may cause the system to
malfunction.
- The operator shall observe the X-Ray safety regulations
WARNING
applicable to their area at all times during the operation
of this equipment.
If an emergency occurs during image acquisition, release
the exposure switch to cease X-Ray emission.
CAUTION
1. Leave the X-Ray room and close the door. The operator must visually
monitor the patient at all times during image acquisition.
2. Press and hold down the exposure switch until image acquisition is complete.
3. The image appears in real time on the imaging GUI.
During X-Ray irradiation, ensure that
- The LED lamp on top of the equipment
t u r n s o r a n g e t o i n d i c a t e X - R a y
emission.
- The warning lamp outside the X-Ray
room turns on.
- The sound (beep or music: optional)
goes off.
- The radiation symbol on the upper left
corner of GUI turns yellow to indicate X-
Rays are being emitted.
PaX-i3D Green (PHT-60CFO) User Manual